ScottB

Thanks! I’ll give that a shot.

Thanks to all for your assistance! I replaced the latch controller, although all the switch lights had gone out, since I had it may as well replace it - right. After replacing all was good, I checked off and on for a week or more all lights were off. However, yesterday after doing some tank cleaning, not running the pump at all, when I went into the coach to prime the tanks with water, again no pump used, I saw the pump light come on and then go off after about 3 seconds??? Today when checked the pump lights are on again and will not turn off. At this point I’m thinking ground issue. Checked wires to pump and gang plug in wet bay which I checked previously, all seem good. Any ideas of other grounds to check?

Have not r&r the part yet, waiting in delivery, supposed to be here tomorrow. I’ll sure let you know when replaced. Of course today when I was searching for the controller all the switch lights were out and are operating properly. Go figure. Still going to replace at your recommendation and see what happens. thanks again.

Thanks, found mine behind the panel with winterizing instruction/diagram in the water bay as well.

Okay, thank you for the info. Assuming the built in relay failed, would that send power to all (3) switches and power to the pump without the switches being pushed. I walked by the coach the a few days ago and heard the pump running, evidently turned on by itself??? None of these will turn off now.

Thank you so much for the response. I will give that a try…

All 3 switches for the water pump will not turn off. I have wired an additional switch between the hot line of the pump to enable the pump to be turned off and on as needed. Could this be a relay issue?. And if so does anyone know where the relay is located? The only relay that I can locate in the wet bay is for the Sanicon thanks